Toshiba nv Series - Name of PF611 A Module Components and Parts

Chapter 2 Name and Function of Module Components
6F8C1872
8
2.2 Name of PF611A Module Components and Parts
Figure 2-3 Name of components and parts
•
Mode 1 setup switch (decimal rotary switch)
Used to specify module internal operation.
•
Set to "4" for PF611A. Set to "4" at shipment.
Do not operate the Mode 1 setup switch
•
Mode 2 setup switch (binary DIP switch)
Used to set the transmission status when there is a controller error.
Table 2-1 Mode 2 setup switch
Mode
MD4
MD5
MD6
MD7
Transmission Status
Stop
OFF
OFF
OFF
OFF
Stops data update of Transmission/Receive.
Resume 1
ON
OFF
OFF
OFF
Resumes transmission using the transmission
data prior to error.
Resume 2
ON
ON
OFF
OFF
Resumes transmission using 0 as transmission
data.
Setting other than above will result in module failure.
MD4 to 7 are all set to "OFF" at shipment.
Status LED
Configurator
port
Reset switch
Transmission
cable
connector
Mode 2
setup switch
Mode 1
setup switch
Mode 1 setup switch