Toshiba nv Series - Transmission Parameter Setup

Chapter 3 Operation, Function and Setup
6F8C1872
18
Output
area
Input
area
Slave(PF612A)
Master(PF611A)
100h
200h
Output
area
Controller
Input
area
PROFIBUS-DP
Input
area
Output
area
200h
100h
Input
area
Controller
Output
area
Figure 3-2 Cyclic transmission (Combination of PF611A and PF612A)
3.3 Transmission Parameter Setup
When using this module, you must set the transmission parameters by the PROFIBUS
configurator, in addition to the controller setup and registration.
About the details of the setting, refer to the manual for the configurator.
The module will be in the DOWN state if the configuration setting is not done by NetTool.
After doing the configuration setting by NetTool when DOWN state, restart the module and
it will start normally.