Toshiba nv Series - Configurator

Chapter 2 Name and Function of Module Components
6F8C1872
14
2.4 Configurator
The PROFIBUS-DP configurator is used to monitor the PROFIBUS status, read/write cyclic
data, and set parameters from a PC.
Use the following configurator for PF611A.
Name :
HMS NetTool
TM
for PROFIBUS Version 1.09.0004 or later
Manufacturer :
HMS INDUSTRIAL NETWORKS AB
Supported OS :
Windows2000/XP/Vista/7/10
 Connecting to PF611A
The PC and PF611A are connected through RS232C. Use the following cable to connect
the RS232C connector of the PC with the CONFIG connector (9 pin male) of the PF611A.
•
Cable : Cross cable with 9-pin male connectors at both ends
(Cross-cable for PC)
Transmission station
9-pin D-SUB
connector (male)
PC
Cable
Figure 2-6 Configurator connection