Toshiba nv Series - 4.2 Installing the Battery to the Controller Module

Appendix C Registration and Setup Procedure (Engineering Tool Ver.4)
6F8C1872
52
Network Variable Registration
Open the Network Variable edit screen from the Talker Block edit screen and register the
network variable name for each Talker Block.
(17) Click the [Open Network] button on the Talker Block edit screen to open the Network
Variable edit screen.
(18) Unlock the [Lock up].
(19) Register network variables to Talker Blocks in the upper half of the Network Variables
edit screen. Talker Blocks can be selected from the [Talker Block] pull-down menu.
(20) Register the network variable as input data in the bottom half of the Network Variables
edit screen. The controller to enter the network variables can be selected from the
[InNode] and [InController] pull-down menus.
(21) In the upper half of the Network Variables edit screen, select the network variables to
output and click the [Assign to Inputs] button to register in the bottom half.
Figure C-7 Network variable registration example