–27–
Owner’s Manual
■4. Schedule timer
(Setting 1-day operation schedule to do operations)
Set the operating schedule for 1 day, and then operate the air conditioner according to that schedule.
You can operate at the same schedule every day, regardless of the day of the week, (“every day”), operate at a
different schedule every day (“week”), or set a day without scheduled operations (“Holiday setting”).
An administrator password may be required.
• The schedule timer does not operate in the following conditions.
When schedule timer is disabled, holiday is set using the schedule timer, the clock is flashing (not set), during abnormalities,
in test mode, during function settings, while a timer is set and operating, and during central control (if “ON/OFF” is prohibited)
• When 2 remote controllers are connected, settings cannot be done on the “Follower remote controller”.
• Before doing “Schedule timer”, do “Clock”. (Page 46)
• The time can be set in 1 minute increments.
• The temperature setting can be set in a range from 64°F to 84°F (18°C to 29°C). (However, if “Set temp. range limit” has
been set, then operation is done within that range)
• Press [ Return] to not fix the changes, so conditions are as before changes, and return to the “Schedule timer” screen.
• The operation mode of “Schedule timer” becomes the operation mode of the previous operation time.
• Operating modes can be selected. For details, refer to “Setting timer operation mode” in “Field setting menu” in the
Installation Manual.
• When “Schedule timer” is “ON”, then “ ” is displayed in the detailed display.
1. In the password screen, press [ ] and [ ] to select numbers, and press
[ ] and [ ] to select the input position
2. After inputting the password, press [ Set/Fix]
* For the initial setting of the administrator password, refer to initial settings
“Password setting” in Installation Manual.
Changing the set
temperature according to
detailed time periods is
troublesome...
Isn’t there a better way?
Timer
1
Timer
2
Timer
3
Timer
4
Timer
5
Timer
6
Timer
7
Timer
8
9:00
Start operation
at 79°F
Solve problem by
using timer to
schedule
operations
Set temperature
Ready
10:00
Change to 81°F
14:00
Change to 81°F
17:00
Change to 79°F
21:00
Change to 81°F
23:00
Change to 81°F
18:00
Change to 77°F
12:00
Change to
77°F
You can turn operations on/off and change the
temperature 8 times throughout each day
81
9:00 12:00 15:00 18:00 21:00 23:00
Off hours
Lunch time
Off hours
Dinner time
Off hours
(°F)
79
77
76
74
72
To Next Page
Loading...
