–39–
Owner’s Manual
Energy saving operation
You can set this to save energy.
▼
Energy saving ratio
• With “Energy saving operation”, operation is done by suppressing the performance of the air conditioners, so cooling
(warming) may be insufficient.
• When 2 remote controllers are connected, settings cannot be done on the “Follower remote controller”.
• Before setting “Energy saving operation”, do “Clock”. (Page 46)
• This setting may not be possible by using the remote controller, depending on the settings of the outdoor unit or central
control device.
• Energy saving schedule operation is not done if the clock is flashing (not set).
• An optional saving ratio of 100% is normal operation.
• When “Energy saving operation” is being done, “ ” is displayed on the screen.
1 In the “Energy saving” screen, press [ ]
and [ ] to select “Energy saving
operation”, and then press [ Set/Fix]
2 Press [ ] and [ ] to select “Energy
saving operation”, and then press [ Set/
Fix]
3 Press [ ] and [ ] to select “ON” or
“OFF”
To start “Energy saving operation”, set “Energy
saving ratio”, “Energy saving time”, and “Energy
saving schedule”.
4 Press [ Set/Fix]
1 In the “Energy saving operation” screen,
press [ ] and [ ] to select “Energy
saving ratio”, and then press [ Set/Fix]
2 Press [ ] and [ ] to change the values
An optional saving ratio can be set within a range of
50 to 100% in 1% increments. The lower the value,
the higher the energy-saving effect on operations.
3 Press [ Set/Fix]
When “ ” appears, return to the “Energy saving
operation” screen.
To Next Page
Loading...
