–43–
Owner’s Manual
Saving operation
• The comfort of a room is determined from such data as the room temperature, fan speed, and outside temperature, which
are averaged over the past 20 minutes to automatically adjust the set temperature to within a range so that comfortableness
does not fluctuate extremely.
• The temperature range for automatic compensation is as shown below.
“Cool”: +3°F to -2°F (+1.5°C to -1.0°C)
“Heat”: -3°F to +2°F (-1.5°C to +1.0°C)
The set temperature display on the remote controller does not change.
• When the operation mode is “Cool”, “Heat”, or “Auto”, “Saving operation” is done.
“Saving operation” cannot be used, depending on the indoor unit that is connected.
• When 2 remote controllers are connected, settings cannot be done on the “Follower remote controller”.
• When “Saving operation” is being done, “ ” is displayed on the remote controller screen.
1 In the “Energy saving” screen, press [ ]
and [ ] to select “Saving operation”, and
then press [ Set/Fix]
2 Press [ ] to select “ON”
If you select “OFF”, the setting is not done.
3 Press [ Set/Fix]
Return to the “Energy saving” screen.
To Next Page
Loading...
