Toshiba Satellite 2670 series - Page 113

User's Manual Optional Devices 8-9
Version
1
Last Saved on 19/01/00 17:28
Satellite 2670/2710 User's Manual – 2670_UK.doc – ENGLISH – Printed on 19/01/00 as
IM_267UK
TV
You can connect a television set to the video-out jack on DVD model
computers. Follow the steps below.
1.
Connect the TV adaptor cable’s mini-jack to the video-out jack on the
computer.
2.
Connect the TV adaptor cable’s RCA jack to the RCA jack on the TV.
You can use the hotkeys
Fn + F5
to change the display device. Refer to
Chapter 5,
The Keyboard
.
Do not connect a TV to the video-out jack and a monitor to the external
monitor port at the same time. If two devices are connected at the same
time, they will not display properly.
The LCD/TV setting can be selected only when the computer is in dual mode.
To set this mode, follow the steps below.
• Click Start, point to Settings and click Control Panel.
• Double-click the
Display
icon to open the Display Properties
window.
• Click the Settings tab and click the
Advanced
button.
• Click the Display Device tab and click the Enable Different
Refresh Rate check box.
If MS-DOS mode is selected, the LCD/TV options will not be available
even if a DVD model.
If a television is connected to the computer, set the TV type in the Display
Properties window for a Windows environment or in TSETUP for a DOS
environment (refer to the TSETUP section in Chapter 7, Setup and
Password Security.
To set the type of TV in Display Properties follow the steps below.
1.
Click
Start
, point to
Settings
and click
Control Panel
.
2.
Double-click the
Display
icon to open the Display Properties window.
3.
Click the
Settings
tab and click the
Advanced
button.
4.
Click the
Display Device
tab and in the TV Standard box select the
format that your TV supports.