7-6 Setup and Password Security User's Manual
Satellite 2670/2710 User's Manual – 2670_UK.doc – ENGLISH – Printed on 19/01/00 as
IM_267UK
Parallel Port Mode
Use this option to set the parallel port mode. See Hardware Setup for details.
Hard Disk Mode
Use this item to select the hard disk mode. The hard disk mode can be set
only in TSETUP.
Formats for Enhanced IDE and Standard IDE are different, so if you
change the setting, you will have to reformat the hard disk for the
appropriate setting.
Enhanced IDE
(Normal)
Select this mode when using MS-DOS, Windows
for Workgroups, Windows 98 or OS/2™. (Default)
Standard IDE
Select this mode when using an operating
system that does not support Enhanced IDE. If
this mode is selected with MS-DOS, up to 504
MB is logically available even though the disk’s
capacity is larger than 504 MB.
Boot priority
This group of option lets you set the computer’s boot priority.
Boot Priority
This option lets you select the disk sequence in which the computer looks
for bootable files. Refer to Hardware Setup for details.
Power on Boot Select
When this option is enabled, you can change the boot drive during start
up. The following message will appear for one or two seconds
Press
[F2] for the boot drive selection menu
.
The message does not appear when you use the Supervisor’s password
to start the computer.
To change the boot drive, follow the steps below.
1.
Press
F2
while the above message is on the screen.
2.
The following menu will be displayed:
Select boot device
[C]: CD-ROM
[F]: FDD
[B]: Built-in HDD
[D]: Default SYSTEM SETUP Device
Press [C], [F], [B] or [D]
Press the key (
C
,
F
,
B
or
D
) corresponding to the desired device.
To Next Page
Loading...
