User's Manual The Keyboard 5-5
Version
1
Last Saved on 19/01/00 17:28
Satellite 2670/2710 User's Manual – 2670_UK.doc – ENGLISH – Printed on 19/01/00 as
IM_267UK
F4
Fn
+
Alarm volume:
Press
Fn + F4
to adjust the alarm volume to off, low, medium
or high. The first time you press
Fn + F4
the volume is set to off. Continue
holding down
Fn
and press
F4
again to change the setting. A beep sounds to
let you know the current alarm volume. The volume at power on depends on
the latest setting. See Chapter 7,
Setup and Password Security
.
Fn
F5
+
Display selection:
Pressing
Fn + F5
changes the active display device. As
indicated in the table below, the changes depend on the computer’s display
type, current setting and whether you have an external monitor connected.
LCD only
LCD/CRT
CRT only
LCD/TV
TV only
(back to LCD only)
Do not connect a TV to the video-out jack and a monitor to the external
monitor port at the same time. If two devices are connected at the same
time, they will not display properly.
The LCD/TV setting can be selected only when the computer is in dual mode.
To set this mode, follow the steps below.
•
Click Start, point to Settings and click Control Panel.
•
Double-click the
Display
icon to open the Display Properties window.
•
Click the Settings tab and click the
Advanced
button.
•
Click the Display Device tab and in the TV Standard box select the
format that your TV supports.
If MS-DOS mode is selected, the LCD/TV options will not be available
even on a DVD model.
If a television is connected to the computer, set the TV type in the Display
Properties window.
To Next Page
Loading...
