7-10 Setup and Password Security User's Manual
Satellite 2670/2710 User's Manual – 2670_UK.doc – ENGLISH – Printed on 19/01/00 as
IM_267UK
Built-in Modem
This option allows you to set the COM level for the built-in modem port.
If a built-in modem (not available in some markets) is not installed, this
selection is not active.
The built-in modem port interrupt request level (IRQ) and I/O port base
address for each COM level is shown below.
COM level I/O address Interrupt level
COM1 3F8H 4
(Default)
COM2 2F8H 3
COM3 3E8H 4
COM4 2E8H 3
Not used
(Disables port)
If the setting for the built-in modem port is the same as that for the Serial
or Parallel port, the port(s) is set to
Not Used
or disabled.
Parallel
Use the Device Manager to change these settings. Refer to your
Windows 98 documentation. The Parallel Port field lets you set the
I/O address for the parallel port and the Parallel Port Mode.
When the Parallel Port Mode (see settings below) is set to Standard
Bi-directional, the options are:
LPT setting I/O address Interrupt level
LPT 1 378H 7
LPT 2 278H 5
LPT 3 3BCH 7
Not Used
(Disables port)
Others
(Other settings made automatically by
plug-and-play operating systems)
To Next Page
Loading...
