Toshiba Satellite A20 Series - Accessing the Setup Program

3 Tests and Diagnostics 3.26 SETUP
3.26.2 Accessing the SETUP Program
Selecting 0 from the DIAGNOSTICS MENU and pressing Enter displays the TSETUP
screen. The TSETUP screen is divided into two pages: SYSTEM SETUP (1/2) and SYSTEM
SETUP (2/2).
SYSTEM SETUP (1/2) ACPI BIOS version = x.xx
MEMORY BOOT PRIORITY
Total = xxxxxxKB Boot Priority = HDD FDD CD-ROM LAN
HDD Priority = Built-in HDD PC Card
SYSTEM DATE/TIME Network Boot Protocol = PXE
Date (MM-DD-YYYY) = xx-xx-xxxx
Time (HH:MM:SS) = xx:xx:xx DISPLAY
Power On Display = Auto-Selected
BATTERY LCD Display Stretch = Disabled
Battery Save Mode = Full Power TV Type = NTSC
PASSWORD OTHERS
Not Registered Power-up Mode = Boot
CPU Cache = Enabled
Level 2 Cache = Enabled
Auto Power On = Disabled
:Select items Space,BkSp:Change values PgDn,PgUp:Change pages
Esc:Exit without saving Home:Set default values End:Save changes and Exit
SYSTEM SETUP (2/2) ACPI BIOS version = x.xx
CONFIGURATION PC CARD
Device Config. = Setup by OS Controller Mode = Auto-Selected
I/O PORTS PERIPHERAL
Parallel = LPT1(378H/IRQ7/CH3) Internal Pointing Device = Enabled
Parallel Port Mode = ECP
DRIVES I/O Hard Disk Mode = Enhanced IDE(Normal)
Built-in HDD
= Primary IDE(1F0H/IRQ14) LEGACY EMULATION
CD-ROM = Secondary IDE(170H/IRQ15) USB KB/Mouse Legacy Emulation
= Enabled
USB-FDD Legacy Emulation = Enabled
PCI BUS
PCI BUS = IRQ11 PCI LAN
Built-in LAN = Enabled
:Select items Space,BkSp:Change values PgDn,PgUp:Change pages
Esc:Exit without saving Home:Set default values End:Save changes and Exit
3-70 Satellite A20 Maintenance Manual (960-444)