4.17 FIR Board 4 Replacement Procedures
4.17 FIR Board
Removing the FIR Board
To remove the FIR board, follow the steps below and refer to figure 4-27.
1. Remove the following screws securing the FIR board.
• M2.5×6 FLAT HEAD screws ×2
2. Disconnect the FIR board from PJ9500 on the system board.
PJ9610
FIR Board
PJ9500
M2.5×6 FLAT HEAD screws
Figure 4-27 Removing the FIR board
Satellite A20 Maintenance Manual (960-444) 4-49
To Next Page
Loading...
