Toshiba Satellite A20 Series - Touch Pad

4.15 Touch Pad 4 Replacement Procedures
4.15 Touch Pad
Removing the Touch Pad
To remove the touch pad, follow the steps below and refer to figure 4-25.
1. Disconnect the touch pad SUMI card from PJ3240 on the system board.
2. Remove the following screw securing the touch pad.
• M2.5×4 FLAT HEAD screw ×1
3. Lift out the touch pad.
Touch Pad
Touch Pad SUMI card
PJ3240
M2.5×4 FLAT HEAD screw
Figure 4-25 Removing the Touch Pad
4. Disconnect the touch pad SUMI card from J1 on the touch pad, if necessary.
Satellite A20 Maintenance Manual (960-444) 4-45