4.9 CPU 4 Replacement Procedures
Installing the CPU
To install the CPU, follow the steps below and refer to figures 4-11 to 4-14.
1. Make sure the cam is in the open position.
2. Seat the CPU in the CPU socket. Make sure the alignment is exact to avoid damaging
pins on the CPU.
3. Press the interposer gently with your fingers and turn the cam on the CPU socket to
the lock position with a flat-blade screwdriver to secure the CPU.
4. Apply new grease on the CPU using a special syringe as shown in the following
figure. Apply quarter of scale (0.25ml) of grease evenly on the CPU chip. When
silicon grease is already applied to the CPU, wipe them off with a close in advance.
CAUTION: When installing the CPU, apply new grease on the top of the CPU
chip. When installing the fin, make sure the bottom of the fin covers the top of the
CPU.
CPU chip
Figure 4-14 Applying new grease
Satellite A20 Maintenance Manual (960-444) 4-29
To Next Page
Loading...
