3 Tests and Diagnostics 3.9 Printer Test
3.9 Printer Test
To execute the Printer Test, select 6 from the DIAGNOSTIC TEST MENU, press Enter and
follow the directions on the screen. The Printer Test contains three subtests that test the
output of the printer connected to the computer. The following messages will appear after
selecting the Printer Test from the DIAGNOSTIC TEST MENU. Answer each of the
questions with an appropriate response to execute the test.
NOTE: A Port Replicator and an IBM compatible printer must be connected to the system
to execute this test.
The following message will appear when the printer test is selected:
channel#1 = XXXXh
channel#2 = XXXXh
channel#3 = XXXXh
Select the channel number (1-3) ?
The printer I/O port address is specified by the XXXXh number. The computer supports
three printer channels. Select the printer channel number, and press Enter to execute the
selected subtest.
Subtest 01 Ripple Pattern
This subtest prints characters for codes 20h through 7Eh line-by-line while
shifting one character to the left at the beginning of each new line.
3-24 Satellite A20 Maintenance Manual (960-444)
To Next Page
Loading...
