4.13 Bluetooth 4 Replacement Procedures
M2×3 SUPER FLAT screw
Bluetooth SUMI card
Bluetooth module
Bluetooth coaxial cable
PJ4900
Figure4-21 Removing the Bluetooth module
Installing the Bluetooth
To install the Bluetooth, follow the steps below and refer to figure 4-21.
1. Connect the Bluetooth SUMI card to the connector on the Bluetooth module.
2. Connect the Bluetooth SUMI card to PJ4900 on the system board.
3. Place the Bluetooth module.
4. Secure the Bluetooth module with the following screw.
• M2×3 SUPER FLAT screw ×1
5. Connect the Bluetooth coaxial cable (brown) to the Bluetooth module.
Satellite A20 Maintenance Manual (960-444) 4-41
To Next Page
Loading...
