4.20 DC-IN Jack 4 Replacement Procedures
Satellite A20 Maintenance Manual (960-444) 4-55
4.20 DC-IN Jack
Removing the DC-IN Jack
To remove the DC-IN jack, follow the steps below and refer to figure 4-30.
1. Disconnect the DC-IN cable from PJ8800 on the system board.
2. Remove the DC-IN jack.
DC-IN cable
PJ8800
DC-IN jack
Figure 4-30 Removing the DC-IN jack
Installing the DC-IN Jack
To install the DC-IN jack, follow the steps below and refer to figure 4-30.
1. Seat the DC-IN jack.
2. Connect the DC-IN cable to PJ8800 on the system board.
To Next Page
Loading...
