4 Replacement Procedures 4.23 PC Card Slot
4.23 PC Card Slot
Removing the PC Card Slot
To remove the PC card slot, follow the steps below and refer to figure 4-33.
1. Lay the system board face up.
2. Remove the following screws securing the PC card slot.
• M2×12 BIND screw ×4
M2
12 BIND screw
PC Card slot
Figure 4-33 Removing the PC card slot
3. Lay the system board face up.
4. Disconnect the PC card slot from PJ2110 on the system board.
4-60 Satellite A20 Maintenance Manual (960-444)
To Next Page
Loading...
