4.23 PC Card Slot 4 Replacement Procedures
Installing the PC card slot
To install the PC card slot, follow the steps below and refer to figure 4-33.
1. Lay the system board face down and seat the PC card slot.
2. Press the PC card slot to connect it to PJ2110. Make sure the connection is secure.
3. Lay the system board face up.
4. Secure the PC card slot with the following screws.
• M2×12 BIND screw ×4
CAUTION: If you do not seat the PC card slot completely, you might not be able
to connect the system board properly. Make sure the PC card slot is connected to
the connector on the system board.
Satellite A20 Maintenance Manual (960-444) 4-61
To Next Page
Loading...
