4 Replacement Procedures 4.13 Bluetooth
4.13 Bluetooth
Removing the Bluetooth
To remove the Bluetooth, follow the steps below and refer to figure 4-21.
CAUTION: Do not try to remove the Bluetooth module with the computer turned on.
You can damage the computer or Bluetooth module. Do not touch the connectors on the
Bluetooth module on the computer. Debris on the connectors may cause Bluetooth access
problems.
1. Remove the Bluetooth coaxial cable (brown) from the Bluetooth module using an
antenna coaxial cable disconnector.
2. Remove the following screw securing the Bluetooth module.
• M2×3 SUPER FLAT screw ×1
3. Lift up the Bluetooth module and disconnect the Bluetooth SUMI card from PJ4900
on the system board.
4. Remove the Bluetooth SUMI card from the connector on the Bluetooth module.
4-40 Satellite A20 Maintenance Manual (960-444)
To Next Page
Loading...
