4 Replacement Procedures 4.10 Keyboard
Installing the Keyboard
To install the keyboard, follow the steps below and refer to figures 4-15 to 4-17.
1. Seat the keyboard face down on the palm rest.
2. Connect the keyboard cable to PJ3230 on the system board.
3. Insert the tabs on the keyboard support plate first, then place the keyboard support
plate on the keyboard cable and secure the keyboard support plate with the following
screw.
• M2.5×6 FLAT HEAD screw ×1
4. Align the tabs on the bottom of the keyboard with the holes on the top cover and
rotate the keyboard down.
5. Secure the keyboard with the following screws.
• M2.5×4 FLAT HEAD screw ×2
6. Place the keyboard hold plate on the keyboard and the switch board. Then secure the
keyboard hold plate with the following screw.
• M2.5×4 FLAT HEAD screw ×1
7. Seat the keyboard brace and press to secure the latches.
4-34 Satellite A20 Maintenance Manual (960-444)
To Next Page
Loading...
