4.5 HDD 4 Replacement Procedures
NOTE: The following steps describe how to disassemble the HDD pack; however, do not
disassemble if the HDD is working properly.
5. Place the HDD pack on a flat surface, and remove the following screws.
• M3×4 FLAT screw ×4
6. Remove the HDD bracket.
7. Remove the aluminum cover.
CAUTION: Do not apply pressure to the top or bottom of the HDD.
M3×4 FLAT screws
M3×4 FLAT screws
HDD bracket
A
Aluminum cover
Figure 4-6 Removing the HDD bracket
Satellite A20 Maintenance Manual (960-444) 4-15
To Next Page
Loading...
