4.7 ODD 4 Replacement Procedures
4.7 ODD
Removing the ODD
To remove the ODD, follow the steps below and refer to figures 4-8 and 4-9.
CAUTION: The ODD can become hot with use. Be careful when removing the module.
1. Remove the following screw securing the ODD cover.
• M2.5×6 FLAT HEAD screw ×2
2. While sliding the latch to the back side of the computer, disconnect the ODD from
PJ1820 on the system board.
Satellite A20 Maintenance Manual (960-444) 4-19
To Next Page
Loading...
