4.29 Wireless LAN Antenna/Bluetooth Antenna/Display Cover 4 Replacement Procedures
4.29 Wireless LAN Antenna/Bluetooth Antenna/Display Cover
Removing the Wireless LAN Antenna/Bluetooth Antenna/Display Cover
To remove the wireless LAN antenna/Bluetooth antenna/display cover, follow the steps
below and refer to figures 4-42 to 4-48.
NOTE: When you open or close the top cover, hold it by the sides close to the hinges to
prevent damage.
1. Remove the latch assembly on the display cover. First, press the inside switch (dark
blue) outward and remove it. Then remove the switch (light blue) by lifting it up.
Switch
(light blue)
Inside switch
(dark blue)
Spring
Slots
Figure 4-42 Removing the Latch assembly
Satellite A20 Maintenance Manual (960-444) 4-73
To Next Page
Loading...
