4 Replacement Procedures 4.30 Fluorescent Lamp
4
4.30.3 Replacing the 15.0-inch XGA Sharp Fluorescent Lamp
Disassembling the 15.0-inch XGA Sharp Fluorescent Lamp
To disassemble the 15.0-inch XGA Sharp fluorescent lamp, follow the steps below and refer
to figures4-67 to 4-76.
1. Turn the LCD module face down, and remove the protection cover S (A), protection
cover G (B), fixing tape (C) and fixing tape for lead wire (C).
NOTE: 1) Be careful not to damage the TCP or chips.
2) The protection cover G is reused. Discard the other tapes removed.
(A) Protection cover S
(C) Fixing tape
(B) Protection cover G
(C) Fixing tape for lead wire
Figure 4-67 Replacing Sharp fluorescent lamp (XGA) (1)
4-104 Satellite A20 Maintenance Manual (960-444)
To Next Page
Loading...
