4.30 Fluorescent Lamp 4 Replacement Procedures
Setting the bezel
1. Start installing the bezel in the upward direction until it stops at the top left corner.
NOTE: The GND-CU and lamp reflector on the left-hand side must not go beyond the
edges of the bezel.
Use care not to damage the cables and TAB.
The bezel latches must be engaged (there are five latches on the top edge, and two latches
on the bottom edge).
ƒ‰ƒbƒ`‚Q‰ÓŠ —L‚èD
ƒ‰ƒbƒ`‚T‚©Š ‚ð‚Í‚ß‚éD
Ÿ‚É‚½‚s‚`‚a‘¤‚ð‚Í‚ß‚éD
ƒP[ ƒuƒ‹‚ðƒLƒY‚‚¯‚È‚¢‚悤‚É ’ˆÓ
ƒxƒ[ƒ‹‚ðƒ‰ƒ“ƒv‘¤‚©‚ç‚Í‚ß‚éD
ƒxƒ[ƒ‹‚ÌŠO‚Éo ‚È‚¢‚±‚ÆD
‚f‚m‚c| ‚b‚tÜ ‚è‹È‚˚—L‚èD
ƒxƒ[ƒ‹‚ÌŠO‚Éo ‚È‚¢‚±‚Æ
ƒŠƒtƒŒƒNƒ^Ü ‚è‹È‚˚—L‚èD
2
2
2
2
2
1
Next, fit the bezel’s edge close to the TAB.
Close the five latches.
First, fit the bezel’s edge close to the lamp.
Use care not to dama
e the cable.
The fold of GND-cu must not go
beyond the bezel’s edge.
The fold of reflector must not go
beyond the bezel’s edge.
Two latches
Figure 4-147 Setting the bezel
Satellite A20 Maintenance Manual (960-444) 4-189
To Next Page
Loading...
