4.30 Fluorescent Lamp 4 Replacement Procedures
Removing the source PCB and gate PCB
10. Remove the source PCB (1).
CAUTION: Pressure or stress should not be given on the PCB and TCP during removing
double tape.
11. Remove the gate PCB (2).
CAUTION: Pressure or stress should not be given on the PCB and TCP during removing
double tape.
Source PCB
Gate PCB
Figure 4-170 Removing the source PCB and gate PCB
Satellite A20 Maintenance Manual (960-444) 4-211
To Next Page
Loading...
