4 Replacement Procedures 4.31 Addendum
Attaching the outside tape and cover shield
15. Attach the tape adhesive (1) used for B/L wire fixing.
CAUTION: Pressure or stress should not be given on the B/L wire fixing.
16. Attach the tape adhesive (2) used for top case fixing.
17. Attach the cover shield (3).
CAUTION: Pressure or stress should not be given on the control PCB.
Usage of the gloves with anti-electric discharge coating is recommended to
eliminate possible damage on the circuits occurred by the ESC
18. Attach the cover shield (4).
CAUTION: Pressure or stress should not be given on the gate PCB.
19. Attach the tape adhesive (5), (6) used for the top case fixing.
CAUTION: Pressure or stress should not be given on the top case during this process.
4-218 Satellite A20 Maintenance Manual (960-444)
To Next Page
Loading...
