4 Replacement Procedures
Satellite/Satellite Pro U500/U500D, PORTEGE M900/M900D Maintenance Manual 4-37
Installing the Top cover
To install the top case, follow the steps below and refer to Figures 4-18 to 4-20.
1. Install the Top cover on the bottom case.
2. Secure the following screws on the Top cover.
• M2×5L FLAT HEAD screw ×4
3. Connect the Touch pad FPC, Power Board FPC, Bluetooth cable, Finger print cable
and Touch pad ON/OFF cable with connector on the main PCB, and turn the bottom
case face down.
4. Secure the following screws on the bottom case.
• M2×5L FLAT HEAD screw ×11
• M2.5×5L FLAT HEAD screw ×2
• M2×7L FLAT HEAD screw ×1
• M2×3L FLAT HEAD screw ×4
To Next Page
Loading...
