4 Replacement Procedures
4.11 Touch pad Board
Removing the Touch pad Board
To remove the touch pad Board, follow the steps below and refer to Figures 4-21 and 4-22.
1. Remove one piece of tape and disconnect the Touch pad board FPC, disconnect the
FPC that connecting the touch pad with touch pad board.
Figure 4-21 Removing touch pad FPC
2. Remove the following screws securing the touch pad board and remove the touch
pad board from the Top cover.
• M2×3L FLATHEAD screw ×2
Figure 4-22
Removing the touch pad Button board
Satellite/Satellite Pro U500/U500D, PORTEGE M900/M900D Maintenance Manual 4-39
To Next Page
Loading...
