4 Replacement Procedures
4.14 Touch pad on/off board and Touch Pad Bracket
Removing the Touch pad on/off board and Touch pad bracket
To remove the touch pad button on/off board and Touch Pad bracket, follow the steps below
and refer to Figure 4-27 and 4-28.
1. Tear one piece of tape and remove the screws as the following which fix the Touch
pad on/off board, and then take the touch pad on/off board out of the top case.
• M2×3L FLAT HEAD screw ×2
Tape
Figure 4-27 Removing the touch pad on/off Board
4-46 Satellite/Satellite Pro U500/U500D, PORTEGE M900/M900D Maintenance Manual
To Next Page
Loading...
