4 Replacement Procedures
4.12 Finger Print board
Removing the Finger Print board
To remove the Finger Print board, follow the steps below and refer to Figure 4-23.
1. Remove the following screws on the Touch pad button board.
• M2×3L FLAT HEAD screw ×2
2. Separate the touch pad button board with finger print board. (be careful about the
connector in case of damage)
Satellite/Satellite Pro U500/U500D, PORTEGE M900/M900D Maintenance Manual 4-41
Figure 4-23 Separating the touch pad board from finger Print broad
To Next Page
Loading...
