Error! No text of specified style in document. Error! No text of specified style in document. 4
Replacement Procedures
[CONFIDENTIAL] Metis 10F/10FG Maintenance Manual 4-17
3. Secure the HDD BRK to the HDD with four M3×3 screws according to the sequence
indicated in Figure 4-7.
Figure 4-7 Installing the HDD aluminum foil
CAUTION: To prevent the HDD aluminum foil from being distorted when installing the HDD
pack into the laptop, do not press the center of the HDD pack. Always hold the HDD pack by
its sides.
4. Insert the HDD into the HDD bay, and slide the HDD inward to connect to the
motherboard.
5. Tighten one M2.5×6 screw to lock the HDD to the logic lower.
6. Replace the HDD door, press down the HDD door.
7. For H95 model: Secure two M2.5×6 screws on the HDD door. (as shown in figure 4-4
H95 model)
For H7 model: Tighten one M2.5×6 screw on the logic lower. (as shown in figure 4-4 H7
model)
To Next Page
Loading...
