Error! No text of specified style in document. Error! No text of specified style in document. 4
Replacement Procedures
[CONFIDENTIAL] Metis 10F/10FG Maintenance Manual 4-37
Installing the Display Assembly
Install the display assembly according to the following procedures:
1. Seat the display hinge brackets in the correct position on the logic lower assembly and
secure it with two M2.5×6 screws.
2. Connect the LVDS cable to the motherboard and adhere the clear tape over the connector
to secure it in place.
3. Route the four antenna cables and the LVDS cable into the routing channel on the logic
lower assembly.
To Next Page
Loading...
