Error! No text of specified style in document. Error! No text of specified style in document. 4
Replacement Procedures
[CONFIDENTIAL] Metis 10F/10FG Maintenance Manual 4-39
4. Pry up the LCD bezel, starting from the bottom edge and toward the top edge.
5. Push up the hinge caps to free it from the LCD hinges and remove the LCD bezel.
Installing the LCD Bezel Assembly
NOTE:
Take care not to pinch the antenna cables. Make sure the routing positions of the antennas are
correct and do not block any components, such as screw holes.
Install the LCD bezel according to the following procedures:
1. Place the LCD bezel assembly on the LCD cover assembly. Make sure the hinge caps fit
over the LCD hinges and the tabs on the back of the LCD bezel align with the slots in the
LCD cover assembly.
2. Press down on the LCD bezel, starting from the bottom edge and toward the sides and top
edge. Make sure the bezel clicks into place.
3. Secure the LCD bezel to the LCD cover assembly with two M2.5×4 screws.
4. Adhere the two screw rubbers to the screws.
To Next Page
Loading...
