Toshiba Satellite U940 - Display Assembly; Removing the Display Assembly

4 Replacement Procedures Error! No text of specified style in document. Error! No text of
specified style in document.
4-36 Metis 10F/10FG Maintenance Manual [CONFIDENTIAL]
4.14 Display Assembly
Removing the Display Assembly
CAUTION:
Use care to avoid the antenna cable being caught between the display assembly and the
laptop.
Remove the display assembly according to the following procedures and Figure 4-19.
1. Peel away the tape securing the two antenna cables (black and white) and the LVDS cable,
and pull the cables from the routing channels on the logic lower assembly.
2. Remove the two M2.5×6 screws securing the display assembly.
3. Remove the display assembly from the logic lower assembly.
Figure 4-19 Removing the screws
M2.5×6*2