This section describes how to determine if the Bridge Media Slot player is functioning
properly. The process is summarized in Figure 2-12. Perform the steps below starting with
Procedure 1 and continuing with the other procedures as required.
Procedure 1: Bridge Media Slot test
Procedure 2: Bridge Media Slot replacement check
Procedure 1 Bridge Media Slot test
The Bridge Media Slot test PLS Use windows application to check device can work fine or
not. Ensure the card in fully inserted into the socket before running the program.
If an error occurs during the Bridge Media Slot test, perform Procedure 2. If no error occurs,
it is likely that the original Bridge Media Slot was faulty.
Procedure 2 Bridge Media Slot socket replacement check
The Bridge Media Slot socket may be damaged or defective, for instance the socket pins can
be bent. Disassemble the computer following the steps described in Chapter 4, Replacement
Procedures and replace the socket. If the problem persists, the system board may be defective
or damaged. Replace the system board with a new one following the steps in Chapter 4.
To Next Page
Loading...
