ADM/DSS Console
DSS Console
Strata CIX IP5000-series Telephone User Guide 95
Transferring to an Idle Station
You can transfer internal or outside calls to an idle station from either a DSS console or a
ADM.
To transfer a call to an idle station
1. Press the DSS button corresponding to the station to be called.
The call is placed automatically on hold. The Line or extension LED flashes green at
double the on-hold rate, and the DSS LED flashes green. You hear a single ring tone.
(If using the Tone signalling mode, you hear successive ring tones.)
2. Announce the call.
With Tone signalling, you would have to wait for the called station to answer before
announcing the call.
3. Hang up.
The call rings the called station when you hang up. While the called station is ringing,
the DSS LED is steady red, and the Line LED flashes green at the on-hold rate or if on
a extension button, it goes idle.
When the called station answers the call, the DSS LED stays steady red, and the Line
LED becomes steady red.
4. If the station does not answer before a period set in system programming, the call
recalls your station.
To Next Page
Loading...
