Feature Operations
Call Forward
54 Strata CIX IP5000-series Telephone User Guide
Station Call Forward Procedures
Table 20 on Page 161 contains Call Forward Button sequences. You can do a Call
Forward function by entering the button sequence as described or by programming a
Programmable Feature Button to perform the sequence. See
“Programming Feature
Buttons” on page 106 to program a Programmable Feature Button.
To use the Call Forward button sequence
Follow the instructions in Table 22 on Page 166, shown under the “Button
Sequence” heading. Some features require additional input, such as:
• Dest. Ext. or Telephone No. – Call Forward destination numbers can be
internal extension numbers or outside telephone numbers. If the destination is
an outside number, enter the access code used for dialling out (such as
9) + the
telephone number +
#. The Strata CIX accepts destination numbers of up to 32
digits.
• Timer – Enter the number of seconds (08~60) your telephone should ring
before forwarding the call. (This is the Call Forward-No Answer timer.)
• Call Forward Pass Code – A four-digit Call Forward pass code can be setup
by your System Administrator and will allow one station to activate the call
forward setting for another station. Users must enter the Call Forward pass code
for the station to be forwarded.
Note In Table 20 on Page 161, (tone) refers to three short tones used as a
confirmation tone and
will play at that point in the sequence to confirm your
input was accepted.
To Next Page
Loading...
