Administrator Programming
IP5131D-SDL Settings
Strata CIX IP5000-series Telephone User Guide 153
Loop Back Test
1. Press +3+6+9 (simultaneously).
2. From the IP Configurations screen, select Net Diag >
Loop Back Test.
Notes
• Press Exit to move back a screen.
• An IP address of current Ping send-to party is displayed in
the second line.
• The result of Ping executed last is displayed in the third
line. (Ping result is confirmed only on this screen.)
Setting Ping Send-to Address
1. Press the Ping Address Setting soft key. The Ping Address
Setting Screen displays (shown right.
2. Using the dial pad, press 1 ~ 0 and * to enter an IP address
or change an IP address. Input the delimiter “.” by
pressing
*
key.
Press
Vol t to backspace.
3. Press
SET soft key to go back to the Loop Back Test
Screen (after rewriting the NV-RAM data if an IP address
is changed). (“Ping to xxx.xxx.xxx.xxx” will display the
IP address after the setting change.)
Note Pressing the Set soft key can cause the screen to move
to the Input Error Screen if an error occurred when
entering the IP address (shown right).
4. Press the OK soft key on the Error Screen to go to the
Address Setting Screen.
Note In five seconds after displaying the Input Error Screen,
the screen automatically moves to the Address Setting
To Next Page
Loading...
