Feature Operations
Alarm Notification Button
Strata CIX IP5000-series Telephone User Guide 49
Alarm Notification Button
The Alarm Notification Button must be setup by your System Administrator on your
station.
When the Alarm Notification button displays
Call your System Administrator.
This button stops displaying when the alarm clears or when you press the flashing button.
If the alarm has not been cleared the Alarm Notification Button starts flashing every 10
minutes.
Automatic Busy Redial
After reaching a busy outside number, you can activate Automatic Busy Redial so that the
system automatically redials the number at regular intervals. The system repeats the
redial until the destination is no longer busy. Check with your System Administrator to
see if this feature is setup for your telephone.
Automatic Busy Redial is not attempted while your station is busy, but continues to time-
out. The system inserts a pause (P) on your LCD before redialling the number.
To activate Automatic Busy Redial
1. When you reach a busy number, press
Auto Busy Redial or + #441. The
LED flashes red. You hear confirmation tone.
2. Hang up or press . The system redials, up to five to 20 times, every 30 to 180
seconds (depending on system programming). Your telephone receives ring tone when
Automatic Busy Redial dials the number and it is available. The extension and Spkr
LEDs flash green.
3. Lift the handset or press and wait for the party to answer. If you do not pick up
the handset or press within recall timeout (five to 60 seconds) after a connection
is made, you hear a muted ring for another 30 seconds, then the call disconnects.
To cancel Automatic Busy Redial
Press
Auto Busy Redial or extension + #442.
To Next Page
Loading...
