Administrator Programming
IP Telephone Function Settings
Strata CIX IP5000-series Telephone User Guide 119
IP Telephone Function Settings
These steps enable you to turn On/Off button beeps, room noise cancellation, handset
Busy Override, and headset volume control. You can also adjust the setting for carbon
headsets vs. non-carbon headsets.
1. Press 3+6+9+ (simultaneously).
2. Press
0 then .
3. Press the Feature Buttons to turn the LEDs On/Off (see Table 16).
4. Press to set the above data.
5. Lift the handset off-hook / on-hook to save the settings.
Table 16 IP Telephone Function Settings
FB LED ON LED OFF
FB1
Buttons beep. (Default) Buttons do not beep.
FB12
Speakerphone/Microphone sensitivity
is lower.
Speakerphone/Microphone sensitivity is
normal. (Default)
FB4
Enable handset Busy Override (BOV)
tone.
Disable handset BOV. (Default)
FB6
Handset carbon supported. Auto (default)
FB11
Turn LED On if carbon headset is
attached.
Turn LED Off if carbon headset is not
attached. (Default - recommended for GN
Netcom Headset GN9330)
To Next Page
Loading...
