SoftIPT
Configuring SoftIPT 3.0
36 Strata CIX IP5000-series Telephone User Guide
2. In the SoftIPT Configuration window, enter the following:
Fields Description
Phone No. This is the SoftIPT extension.
Password Password for IP user mobility.
Node The node ID where the MIPU resides. By default, leave blank.
Outgoing prefix When a call is made using the SoftIPT directory, SoftIPT
automatically attaches the outgoing prefix for local calls, or long-
distance prefix for long-distance calls, respectively. See
“Usinging the Directory” on page 42 for details.
Long distance prefix
IP address of IPU
SoftIPT tries to connect to the IPU using the following addresses
in turn:
• Primary IPU IP address
• Secondary IPU IP address.
Notes
If Broadcast is selected, SoftIPT tries to search for the IPU by
sending broadcast messages, otherwise, it goes back to the
Primary IPU IP address. SoftIPT skips the Primary IPU IP
address or the Secondary one if it is not set. In either case, if
SoftIPT successfully connects to the IPU, the IPU IP address is
shown in the "Connected IPU IP Address" field. See your
System Administrator for IPU address.
If Broadcast is selected, the broadcast message is sent on the
same subnet, which means SoftIPT can connect to the IPU on
the same subnet using Broadcast mode without designating the
IPU IP address. However, in some PC environments, SoftIPT
cannot complete this broadcast registration sequence because
the lower network module does not notify SoftIPT, through
Windows, of receiving a reply message after sending a
broadcast message. Therefore, Toshiba recommends using
Manual mode if SoftIPT cannot find the IPU by Broadcast.
Network If there are multiple network adapters, select the one for SoftIPT.
To Next Page
Loading...
