E6581697
K-40
11
11.8 Unchangeable parameters in running
For reasons of safety, the following parameters cannot be changed during inverter running.
Change parameters while inverter stops.
［Basic parameters］
(Guidance function) *1(Frequency setting mode selection)
(Overload characteristic selection) (Maximum frequency)
(Automatic acceleration/deceleration) (V/F control mode selection)
(Torque boost setting macro function) (Default setting)
*1 (Command mode selection) (Checking the region setting)
［Extended parameters］
to to
to
/ / ,
, to
to / / / /
to
to / / / /
, to
,
,
/ to
to to
/
*1: and can be changed during operation by setting =.
Note) Refer to “Communication manual” about parameter Cxxx.
To Next Page
Loading...
Need help?
General