Toshiba TOSVERT VF-MB1 - Page 57

E6581697
C-6
3
(3) Coast stop
The standard default is deceleration stop. To make a
coast stop, assign "6 (ST)" to an idle terminal.
Set parameter =.
For coast stop, open the ST-CC when stopping the
motor in the state described at right. The monitor on
the inverter at this time will display .
A coast stop can also be made by assigning "
(FRR)" to an idle terminal.
When doing this, a coast stop is done by shorting
FRR and CC.
Motor
speed
ON
OFF
ON
OFF
F-CC
ST-CC
Coast stop