DUST-PROOF/WATER-PROOF TYPE INDUSTRIAL ROBOT SPECIFICATIONS MANUAL
1.5.2 Operating Posture
Do not attempt to move Axis 1 and Axis 2 individually during automatic operation with
the arm fully extended as shown in Fig. 1.6 below. Failure to observe this instruction
will cause a breakdown the motor and the decelerator in early stages.
If it is necessary to move Axis 1 and Axis 2 individually, fold Axis 3 in advance before
doing so.
Fig. 1.6 Cautions for Operating Postures
STE 85338
– 13 –
To Next Page
Loading...
