DUST-PROOF/WATER-PROOF TYPE INDUSTRIAL ROBOT SPECIFICATIONS MANUAL
3. Installation
3.1 Installation Environment
Table 3.1 shows the environmental conditions for the location in which the robot and
controller are to be installed.
Table 3.1 Environmental conditions for robot and controller
Item Specifications
In operation : 0 to 35°C
*1
Temperature
In storage : –10 to 50°C
Humidity 20 to 90 % (Non-condensing)
DO NOT install the robot where it may be subject to fluids
such as water.
Altitude 1000m or less
Vibration In operation : 0.98m/s
2
or less
Dust No inductive dust should exist.
Gas No corrosive or combustible gas should exist.
Sunlight The robot and controller should not be exposed to direct
sunlight.
Power noise A heavy noise source should not exist nearby.
Magnetic field A heavy magnetic field source should not exist nearby.
Dust-proof/
Drip-proof
Conform to Item 1.4.
Not used in an environment where small grinding chips are
produced during turning, cutting, and other machining
processes.
Not used in an environment exposed to mists from cutting
oil, coolant, and similar substances.
*2
*1: In an environment with temperature of 35
°
C or higher, especially watch for the
ambient temperature during operation, and cool off the robot as necessary. Or,
please contact us.
*2: We provide heat-resistant jackets as optional products for severe environments.
Please consult us for the application of these jackets.
STE 85338
– 15 –
To Next Page
Loading...
