DUST-PROOF/WATER-PROOF TYPE INDUSTRIAL ROBOT SPECIFICATIONS MANUAL
5.3.1 Base Covers
There are two covers for the base section: the base cover and connector panel.
Each cover is secured to the base by four bolts with a rubber packing inserted in
between. The connector panel is connected to connectors inside the robot, and so it
must not be pulled with excessive force. When mounting the cover, be careful that no
cables get pinched in between.
Packing
Base cove
* The internal cables are
omitted from the
illustration.
Packing
Connector pane
l
Fig. 5.1 Base cover and connector cover
!
CAUTION
• Be sure to always insert the packing. Also, be sure to apply Loctite to the
mounting bolts. Failure to apply Loctite will result in reduced
dust-proof/drip-proof performance and the ingress of water and dust.
• Packing that has been removed cannot be reused. Replace with new packing.
STE 85338
– 22 –
To Next Page
Loading...
