DUST-PROOF/WATER-PROOF TYPE INDUSTRIAL ROBOT SPECIFICATIONS MANUAL
STE 85338
– 21 –
5.2 Maintenance Tools and Required Items
Preparation of the maintenance tools and items below is recommended.
For details about tools and items other than those shown below, refer to the
TV800/TV1000/TV1000H Instruction Manual: Maintenance.
⋅ Phillips-head screwdriver
⋅ Hexagonal spanner set M3 to M16
⋅ Scraper
⋅ Liquid gasket (Recommended product: 1221H Manufactured by ThreeBond)
⋅ Loctite (242: Medium strength)
⋅ Grease for coating O-rings
5.3 Mounting and Removing the Covers
Packing or O-ring is fitted onto the cover mounting surfaces of the
dust-proof/water-proof type industrial robot. Be sure to carefully follow the procedures
in this section when mounting and removing the covers.
!
DANGER
• Be sure to always turn off the main power (POWER) switch before mounting or
removing the covers.
• When opening a cover, be careful that no moisture or foreign matter gets
inside the robot. Turning on the power with moisture or foreign matter inside
can cause an electrical shock and failure and is extremely dangerous.
To Next Page
Loading...
